Astm Test Standard For Ballast Aggregates

المنتجات الساخنة

Standard Classification for Size of Aggregate Used as

ASTM D7655 / D7655M 12 (2017) Standard Classification for Size of Aggregate Used as Ballast for Membrane Roof Systems. Products and Services / Standards & Publications / Standards Products. Products and Services. Standards & Publications. Standards Products.

Contact

ASTM C295 / C295M 19 Standard Guide for Petrographic

C33/C33M Specification for Concrete Aggregates. C117 Test Method for Materials Finer than 75-m (No. 200) Sieve in Mineral Aggregates by Washing. C136/C136M Test Method for Sieve Analysis of Fine and Coarse Aggregates. C294 Descriptive Nomenclature for Constituents of Concrete Aggregates. C702/C702M Practice for Reducing Samples of Aggregate to Testing Size

Contact

ASTM C123 / C123M 14 Standard Test Method for

Scope. 1.1 This test method covers the determination of the percentage of lightweight particles in aggregate by means of sink-float separation in a heavy liquid of suitable specific gravity. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard.

Contact

ASTM D7655/D7655M Standard Classification for Size of

ASTM C136/C136M Standard Test Method for Sieve Analysis of Fine and Coarse Aggregates Published by ASTM on December 1, 2019 This test method covers the determination of the particle size distribution of fine and coarse aggregates by sieving. Some specifications for aggregates which reference this test method contain...

Contact

SECTION 20110 BALLAST AND WALKWAY AGGREGATE

2011. 9. 30. 2. Test all samples of ballast material for conformance with ASTM D75. Sample sizes shall be sufficient to provide the minimum sample sizes required by the designated test procedures. Reduce test samples from field samples in conformance with ASTM C702. 3. If the ballast consistently fails the gradation test for excess materials

Contact

ASTM C40 / C40M 20 Standard Test Method for Organic

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard. ASTM Standards. C33/C33M Specification for Concrete Aggregates. C87/C87M Test Method for Effect of Organic Impurities in Fine Aggregate on Strength of Mortar

Contact

(PDF) ASTM D75-87 Method of Test for Sampling of

Standard acceptance and control tests are covered by ASTM standards and specify the portion of the field sample required for each specific test. Generally speaking, the amounts specified in Table 1 will provide adequate material for routine grading and quality analysis.

Contact

ASTM C295/C295M 19 Standard Guide for Petrographic

Standard Number: ASTM C295/C295M 19: Title: Standard Guide for Petrographic Examination of Aggregates for Concrete: Status: Current: Publication Date: 01 August 2019: Normative References(Required to achieve compliance to this standard) No other standards are normatively referenced: Informative References(Provided for Information)

Contact

ASTM C142 Standard Test Method for Clay Lumps and

ASTM C117 Standard Test Method for Materials Finer than 75-μm (No. 200) Sieve in Mineral Aggregates by Washing Published by ASTM on August 1, 2017 This test method covers the determination of the amount of material finer than a 75-μm (No. 200) sieve in aggregate by washing.

Contact

ASTM D3042 Standard Test Method for Insoluble Residue

Standard Test Method for Insoluble Residue in Carbonate Aggregates This test method covers determination of the percentage of insoluble residue in carbonate aggregates using hydrochloric acid solution to react the carbonates. The values stated in SI units are to be ASTM D3042

Contact